Skip to main content

Check Us Out

No Job Too Big Or Small

Low Water Pressure in Your Henderson Home? Start With One Question

November 18, 2026

The kitchen faucet barely fills a pot, but the bathroom sink seems fine. Or maybe the shower slows to a trickle every time the washing machine fills. Both feel like low water pressure, but they point you in different directions.

Before you call a plumber, check one thing. Is the weak flow coming from one fixture or several? That’s the quickest way to narrow down where to look.

If it’s just one faucet or shower

Try another fixture nearby. If the bathroom sink runs normally but the shower is weak, start with the showerhead. If it’s only the kitchen faucet, check the aerator, the small screen at the end of the spout. Mineral buildup or debris can restrict flow through either one.

It also helps to compare hot and cold at the same fixture. If only one side is weak, tell your plumber. That detail can help them narrow down whether to look at the faucet itself or the line feeding it.

If it’s only the hot water

Run the hot and cold water separately at the kitchen sink and at another sink. If cold water flows normally in both places but hot water is weak in both, the issue may be somewhere along the hot water supply.

Pay attention to whether the flow is weak from the moment you turn on the tap or whether it starts strong and the water goes cold later. Those are two different symptoms, and describing which one you’re seeing gives your plumber a better starting point.

If the whole house has low water pressure

Think about when you first noticed it. Did it start right after plumbing work? Does it happen only when the washer or another fixture is running? Did the flow drop suddenly at every tap?

If the change was sudden and affects both hot and cold water throughout the house, check whether a neighbor noticed it too. If they did, contact your water provider to ask about nearby work or a service interruption. If it seems limited to your house, a plumber can measure the incoming pressure and check for issues such as a partly closed shutoff valve, a faulty pressure regulator, or a restriction in the supply line.

What to tell your plumber

You can make the first call more productive with three details:

  • Where it happens. One faucet, one bathroom, or the whole house.
  • Which side is affected. Hot water, cold water, or both.
  • When it happens. All day, when another fixture is running, or since a specific repair or change.

If low water pressure keeps coming back or affects several fixtures, contact Pipe Pros Plumbing & Mechanical in Henderson, NV. Tell us what you’ve noticed so we can start looking in the right place.

Disclaimer: This article is for general information. Plumbing systems vary by home, and the checks above can help describe a problem but cannot diagnose its cause. Contact a licensed plumber if the issue persists or you’re unsure how to proceed.